What Is The Correct Spacing For Exterior Board And Batten?

Answer:

How To Install Board and Batten Siding. To install board and batten siding, first install wide vertical boards, spaced approximately one board width (7/8″) apart. Secure these boards using fasteners fasteners placed at the center of the siding boards.

Answer:

For board and batten siding, it’s essential for the boards to be spaced and installed correctly. In most cases, the battens, which are the strips of narrow wood, should be spaced anywhere between 12” and 24” apart. Consult a professional if you need help deciding how yours should be spaced. Does board and batten come in vinyl?


ProTradeCraft LIVE: Board and Batten Siding Layout Basics for Remodel or New Construction


LP Home 3: Smartside Expert Finish Installation Part 1


Board and Batten Siding


Frequently Asked Questions

What is the best spacing for board and batten?

Typically, batten are spaced anywhere from 12” to 24” apart. I think it looks best to space them as close to 18” as possible, but that's just a personal preference.

How do you space exterior board and batten?

The 240-inch wall-length minus the 75 inches of total batten width would leave you with 165 inches of wall length minus the batten space. Finally, divide the 165 inches of wall length minus the battens by the 24 spaces calculated initially. So, you would have a spacing of 6.9 inches between each batten.

How is spacing for board and batten calculated?

5:3913:16How to measure spacing, choose trim, & install board and batten!YouTubeStart of suggested clipEnd of suggested clipPiece once you have the top and bottom moldings in place you can move on to figuring. Out thisMorePiece once you have the top and bottom moldings in place you can move on to figuring. Out this spacing you want between all of your board and batten pieces.

How wide are battens on board and batten siding?

The battens are usually (but not always) about 1/2-inch wide.

What should the spacing be between siding and batten?

Now you are ready to install the siding boards. The spacing in between the boards should be at least 1/4" for movement of the boards but make the gap such a width that you can nail the batten through the space to prevent splitting the board edges.

What do you need to know about board and batten spacing?

Batten Spacing Traditional batten spacing was dictated by the width of the boards being used. If the boards were 12-inches wide, then that was the batten spacing. If the boards were 8-inches wide, then the battens were installed 8 inches apart.

Add a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.