How To Finish Rough Plumbing For Bathroom Vanity?


DIY New bathroom rough plumbing from scratch part 2


Frequently Asked Questions

How do you lay out rough plumbing?

Steps for Roughing in your Plumbing:

  1. Step 1)Mark Key Locations. Determine where all the toilets will be and mark its center on the wall and measure out 13 1/2 inches from that point. ...
  2. Step 2) Cut the Drain Hole. ...
  3. Step 3) Drain Pipe Installation. ...
  4. Step 4) Supply Line Installation.

What is the rough in height for a bathroom vanity?

The water supply line runs out of the wall into a hole in the back of the vanity, typically placed at a height of 22 to 24 inches from the finish floor.

How do you rough in a bathroom vanity?

Roughing in plumbing involves measuring, cutting and a basic knowledge about plumbing in a bathroom. Measure the height of the vanity from the top of the sink to the floor. Place a tape measure against the wall where the vanity is to be installed with the top of the tape against the floor. Make a mark on the wall at the height of the vanity.

What kind of plumbing do you need for a vanity?

When installing a vanity, you must rough in three pipes: the drain and two supply lines for hot and cold water. Roughing in plumbing involves measuring, cutting and a basic knowledge about plumbing in a bathroom.

Add a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.